X1 Canbus RESISTOR for H7 kit Led Bulbs | Warning ERROR FREE Canceller Anti-Flicker Decoder Control Unit

Description

1 NEW Canbus Professional Filter For FULL LED H7 TRANSFORMATION KIT | Error Free Warning, Anti Flicker Decoder | Plug & Play Chain-connected NO Modifications

(ATTENTION: Success cannot be guaranteed mathematically, but WE GUARANTEE "Satisfied or Refunded" Formula = It will be Possible to return the product for a Total Refund) READ INFO in DESCRIPTION

- Plug and Play (H7 Connectors)
- Excellence of materials Quality used
- It Removes the Error light
- It Removes flashes and flickers
- It Removes Radio Interference


WE GUARANTEE THE QUALITY AND POWER OF THIS FILTER AS A TOP OF THE RANGE ON THE MARKET


THE PACKAGE INCLUDES:

- 1X CANbus Filter Resistor H7


INFO:

Additional CANbus Resistor Control Unit, for Installation of H7 LED Bulbs. Erases Errors and Malfunctions on Low or High Beam, Fog Lights etc. Built with High Resistance Materials and Finishing, with ABS Body and Connectors.


MINIMUM SIZE
It is currently the SMALLEST Electrolytic Condenser Filter on the market

IT HAS H7 SOCKET LIKE YOUR CAR
No need of adaptations or modifications of the cables, just Plug and Play

CANBUS NO ERRORS - NO FLICKERS - NO RADIO INTERFERNCES
Equipped with 10.000uf Capacitor (Microfarad) 16V.

HOW DOES IT WORK
Many cars after the installation of LED lamps (parcking light, turning lights, low beam...): they can detect LIGHTS FAILURES, they FLICKER WHEN STARTING THE CAR, they TURN OFF, they have a LOW POWER, and in some cases there are interferes on RADIO RECEPTION.

These phenomena are due to the car Canbus control system, which usually detects an absorption (watts of the classic halogen lamp) much higher than that of the LED, which remains paltry in comparison, and consequently detect the new lamp as burned.
This type of filter is nothing more than an electrolytic capacitor capable of increasing absorption, and filtering voltage, to evade the car's CANBUS SYSTEM

CASE OF FAILURE
It may depend on two factors; Full led absorption is much lower than stated; Canbus System is too Restrictive.
" In These Cases you can RETURN the Product for a TOTAL REFUND "

COMPATIBILITY:

- FULL LED H7 KIT


FOR AN OPTIMAL MOUNTING, WE RECOMMEND:

- CHECK: Connect only the Sockets (PLUG AND PLAY); if there are no problems, proceed with the assembly

- CONNECT MALE SOCKET: Connect the male socket to the CAR

- CONNECT FEMALE SOCKET: Connect the Full Led Kit to the Female Socket

- CHECK: Start the vehicle to check if there are no problems, only then proceed to lock the LED bulb.

- INSTALLATION: Repeat the operation on the second headlight

It is PREFERABLE to keep the resistors out of the headlight, since the lower the overheating is, the longer the DURATION OF YOUR LED KIT WILL BE.



NON-STANDARD CASES

- DEEPER DUST CAPS:
Mounting a TRANSFORMATION kit, and not simple spare bulbs, it has bigger dimensions. If the installation of the kit does not allow the closure of the lighthouse, visit our store for the DEEPER DUST CAPS.


We do not take responsibility for: erroneous purchases - violations of regulations or laws of any state - damages, which you may cause to you, to third parties or to the same article, as we describe each individual specification in detail.

We also remind you that, these are Aftermarket Items, designed for full compatibility and operation on the designated vehicle, but there remain products that may not be allowed for use on the public road.

We trust in your common sense.